UT1088L启动信息
来自IPTV爱好者
==启动信息==
TANGO15 boot loader v0.19.20 for generic2/unnamed board Loaded to 0x90060000 Booted from parallel flash. CPU freq.: 202 MHz DRAM size is 128MB (128MB/0MB) EEPROM Flag: Normal AA,Backup AA Start kernel from Normal Image ROMFS found at 0x46340000, Volume name = rom 473801b1 File linux.bin.gz found Unzipping image from 0x464B2400 to 0x90090000, size = 888772 Inptr = 0x00000014(20) Inflating.... Outcnt = 0x001da148(1941832) Final Inptr = 0x000d8fbc(888764) Original CRC = 0x6506fc20 Computed CRC = 0x6506fc20 Boot kernel at 0x90090000 with ROMFS at 0x46340000 Boot kernel at 0x90090000 with ROMFS at 0x46340000 Linux version 2.4.22-uc0-sigma-20051018-nm (zfji@stb138server) (gcc version 2.95.3 20010315 (release)) #402 Mon Nov 12 15:32:41 CST 2007 Found bootloader memory map at 0x10000fc0. Processor: ARM pt110 revision 0 Architecture: EM86XX Tango15 Rev B (kernel supports Rev B) Board name is generic2 On node 0 totalpages: 23040 Free page pool initialized (size=512) zone(0): 23040 pages. Warning: wrong zone alignment (0x90080000, 0x0000000c, 0x00001000) zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/blkmem/0 Console: colour dummy device 80x30 serial_em86xx: setup_console @ 38400 Calibrating delay loop... 100.96 BogoMIPS Memory: 90MB = 90MB total Memory: 88244KB available (1727K code, 1034K data, 80K init) Dentry cache hash table entries: 16384 (order: 5, 131072 bytes) Inode cache hash table entries: 8192 (order: 4, 65536 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) POSIX conformance testing by UNIFIX PCI: bus0: Fast back to back transfers disabled PCI: Configured EM86XX as a PCI slave with 128MB PCI memory PCI: Each Region size is 16384KB PCI: Reserved memory from 0x10080000 to 0x15a80000 for DMA and mapped to 0x12000000 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 skbmem: allocated 0x400000 from 0x95080000-0x95480000 Initializing RT netlink socket Starting kswapd devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB. udf: registering filesystem pty: 256 Unix98 ptys configured EEPROM Flag: Normal AA,Backup AA Start kernel from Normal Image blkmem_init: romfs address 00340000 Relocate blkmem to address 46340000 Blkmem copyright 1998,1999 D. Jeff Dionne Blkmem copyright 1998 Kenneth Albanowski Blkmem 1 disk images: 0: 46340000-469B13FF [VIRTUAL 46340000-469B13FF] (RO) RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize PPP generic driver version 2.4.2 PPP MPPE compression module registered 8139too Fast Ethernet driver 0.9.27 Succeed to register char dev ethdrv_cbk in e100 for ip filter. eth0: RealTek RTL8139 at 0x58000000, 00:07:ba:ca:18:70, IRQ 14 SCSI subsystem driver Revision: 1.00 Probing EM86XX Flash Memory Amd/Fujitsu Extended Query Table v1.3 at 0x0040 number of CFI chips: 1 Using buffer write method [TOS] cfi_cmdset_0002:: buswidth = 0x1. cfi_cmdset_0002: Disabling fast programming due to code brokenness. Creating 2 MTD partitions on "EM86XX mapped flash": 0x00e00000-0x01000000 : "User" 0x00000000-0x00e00000 : "System" usb.c: registered new driver usbdevfs usb.c: registered new driver hub ehci_hcd 00:02.2: PCI device 1106:3104 ehci_hcd 00:02.2: irq 15, pci mem 60100100 usb.c: new USB bus registered, assigned bus number 1 ehci_hcd 00:02.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4 hub.c: USB hub found hub.c: 4 ports detected host/usb-uhci.c: $Revision: 1.275 $ time 15:32:46 Nov 12 2007 host/usb-uhci.c: High bandwidth mode enabled host/usb-uhci.c: USB UHCI at I/O 0x58000400, IRQ 15 host/usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected host/usb-uhci.c: USB UHCI at I/O 0x58000420, IRQ 15 host/usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 3 hub.c: USB hub found hub.c: 2 ports detected host/usb-uhci.c: v1.275:USB Universal Host Controller Interface driver Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 8192) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. FAT: bogus logical sector size 58784 UMSDOS: msdos_read_super failed, mount aborted. FAT: bogus logical sector size 58784 FAT: bogus logical sector size 58784 VFS: Mounted root (romfs filesystem) readonly. Mounted devfs on /dev Freeing init memory: 80K [: not found [: not found ok [: not found [: not found [: not founBINFMT_FLAT: Loading file: /etc/init.d/S30iptv d insmod: /lib/modules/2.4.22-uc0-sigma-20051018-nm: No such file or directory Using /lib/modules/fip.o usb.c: registered new driver hiddev usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>, NanYuanJun<yjnan@utstar.com> hid-core.c: USB HID support drivers and fip drivers I2C_MCU: major number:[252] IRKey: major number:[253] mcu_led: major number:[251] KEY ServI2C_MCUWrite::devaddr=68 content =11a1a03 data =3 n =4 er started. I2C_MCUWrite::devaddr=68 content =99a0000 data =0 n =4 insmod: /lib/modules/2.4.22-uc0-sigma-20051018-nm: No such file or directory Using /lib/modules/llad.o Warning: loading llad will taint the kernel: non-GPL license - LGPL See http://www.tux.org/lkml/#export-tainted for information about tainted modules Using /tmp/em8xxx.o Warning: loading em8xxx will taint the kernel: non-GPL license - Proprietary See http://www.tux.org/lkml/#export-tainted for information about tainted modules mumk_register_tasklet: (0) tasklet 9087d740 status @943dc5a4 insmod: /lib/modules/2.4.22-uc0-sigma-20051018-nm: No such file or directory eeprom: init_module() 0x1 Using /leeprom: Device sucessfully registered ib/modules/ee.o insmod: /lib/modules/2.4.22-uc0-sigma-20051018-nm: No such file or dirvencoder: major number:[231] ectory Using /lib/modules/vencoder.o Invalid parametersInvalid parameters now sizeof(netConfig_t) = 140 config->netConfig.userName_DHCP60 = config->netConfig.password_DHCP60 = 123456 OSD buffer size : 720x576 OSD format : tc:32bpp Color Anti Flicker : 3 Alpha Anti Flicker : 3 begin get_osd_infos surface = 0x00000000, surf addr=0x94da88f4